Scranton Roof Pros provides professional fascia & soffit in Scranton, PA for residential and commercial properties across the Lackawanna Valley. The eave is where the roof hands off to the wall, and in Scranton's older neighborhoods it is usually not a modern eave at all. A boxed cornice built from dimensional lumber and moldings, closed underneath, with no vented soffit panel in it and no intention of ever having one.
Rot is the common failure and it starts in predictable places. Behind a split gutter end cap, at a joint where the edge metal never overlapped the underlayment, or under a downspout outlet dripping onto the same short length of board for a decade. We test it with an awl, cut back until the wood is sound, fit a new member rather than covering the old one, and correct whatever delivered the water.
Wrapping soft fascia in aluminum coil is the shortcut we get hired to undo. It hides the rot, holds it wet, and buys ten quiet years that end at the rafter tails. We will wrap sound fascia gladly, because it is a good long-term finish and it stops the painting. We will not wrap a board that is already going, and we will show you the probe holes.
On a boxed cornice there is a decision to make rather than a repair to do. Since there is no soffit to vent, the attic behind it is getting no intake at all, and the ridge vent above is drawing air from wherever it can find it. Opening an edge or fascia intake during eave repair is the cheapest chance you will ever get at fixing that.
Attached houses bring the ownership question to the eave more sharply than anywhere else on the building, because the fascia runs continuously across the front of both halves. The board does not stop at the deed line and neither does the rot. We measure and quote it in two columns split at that line, so each owner can see the feet they are being asked to pay for.
What we do not do is shim a fascia line straight when the reason it dipped is structural. A run that sags in the middle, or a soffit opening a wedge against the wall that is wide at one end, is telling you about the building rather than the board. That gets photographed, dated and written up, and the next call is not a carpenter.
Our licensed and insured team brings the right materials and equipment to every job — a DEP mine viewer result recorded with the map sheet number, square-edge board sheathing gauged for nail withdrawal before tear-off, SBS-modified laminated shingles chosen for cold-weather flexibility, self-adhered membrane lapped up the party wall of a double block, W-profile valley metal formed with a raised center rib, eave intake cut into a boxed cornice that never had a soffit — and backs the work with a written workmanship warranty. We serve Scranton and nearby communities including Dunmore, Carbondale, Old Forge, Pittston.
What We Handle
Everything our fascia & soffit in Scranton covers
One crew, one point of contact, and the full range of fascia & soffit work in Scranton, PA. If it is on this list we do it in house rather than handing it to a subcontractor:
- fascia repair
- soffit replacement
- rotted fascia board
- aluminum fascia wrap
- vented soffit panels
- boxed cornice repair
- rafter tail repair
- soffit intake ventilation
- fascia and gutter apron
- wood fascia replacement
- eave repair
Not sure which one describes your situation? Describe it in plain words and we will sort it out — or browse the rest of our Scranton services.
Materials, equipment and how we do fascia & soffit
The difference between fascia & soffit that lasts and fascia & soffit that gets redone in three years is almost always preparation and materials, not the finish you see on day one. We work with a DEP mine viewer result recorded with the map sheet number, square-edge board sheathing gauged for nail withdrawal before tear-off, SBS-modified laminated shingles chosen for cold-weather flexibility, self-adhered membrane lapped up the party wall of a double block, spec them to the job instead of to the invoice, and write the material grades into the free estimate so you know exactly what you are buying.
Every Scranton job runs the same way: site walk and measurements, written scope and fixed price, protection of the surrounding area, then the work itself with a daily clean-up. Years of roofing work in the Lackawanna Valley means we have already met whatever your property is going to throw at us — awkward access, older construction, an HOA with opinions.
Where we do fascia & soffit outside Scranton
Scranton Roof Pros covers Scranton and the surrounding communities of the Lackawanna Valley. Crews run out to the same nearby cities every week, so an out-of-town job does not mean an out-of-town price.
- Fascia & Soffit in Dunmore, PA — Lackawanna County, population 14,042
- Fascia & Soffit in Carbondale, PA — Lackawanna County, population 8,828
- Fascia & Soffit in Old Forge, PA — Lackawanna County, population 8,497
- Fascia & Soffit in Pittston, PA — Luzerne County, population 7,591
- Fascia & Soffit in Archbald, PA — Lackawanna County, population 7,297
- Fascia & Soffit in Blakely, PA — Lackawanna County, population 6,657
Start on the Scranton Roof Pros homepage for a free estimate, or call (844) 511-2320 and describe the job.
Why Scranton Chooses Scranton Roof Pros
- ✓We look your address up on the department's mine viewer before we quote, because in this valley the answer changes whether a roof is the right thing to buy this month at all.
- ✓Pennsylvania sells subsidence cover separately instead of writing it into your policy the way the statute does in Illinois, so here the first question is whether any coverage exists, not which of two perils to file under.
- ✓On a house with a mapped void and no policy we will hand you the department's phone number and leave without a signed contract, because forty-one dollars a year outranks anything on our price list.
- ✓We refuse to coat over a split detail. Beyond hiding evidence, unrepaired damage can block the Commonwealth from issuing a policy at all until the repairs are made as its board directs.
The standards behind fascia & soffit
Quality here is not a matter of opinion — it is written down. The fascia & soffit work we do in Scranton follows published industry standards: NRCA publishes the Roofing Manual, the industry's reference for details and slope minimums, and Asphalt Roofing Manufacturers Association sets the shingle application and ventilation guidance the warranties reference. If a contractor cannot tell you which standard a detail comes from, that is worth asking about before you sign.
Every fascia & soffit project in Scranton gets the same attention, whether it is a single room or a full commercial job. We show up on schedule, keep the site clean, and stand behind the work — the estimate is free and there is no pressure.
Ready to get started? Call (844) 511-2320 for a free fascia & soffit free estimate in Scranton, or request a quote and we'll get right back to you.